Martin Doors - Quality, Strength and Security

PHONE
(321) 821-0752

Your Great Garage of Brevard and Indian River sells and installs Martin Garage Doors in Brevard and Indian River Counties, Florida, including Vero Beach, Melbourne, Palm Bay, Viera, Suntree and Rockledge. Martin Doors® is known for their safety features, inspiring the door industry to greater heights and expectations. Quality Martin Doors® are designed to enhance the beauty and security of your home.

Back to MARTIN DOORS

BC Overhead Doors HOME

E-Mail Us

Woodline Short Panel	Ranch Long Panel	Hi-Tensil Ribbed	Super Steel Short Panel	Super Stee Long Panel
Camelot Mixed Panel	Flushline Insulated	Montana Long Panel	Copper Doors	Carriage House Wood

Quality, Strength and Security are what makes Martin Doors stand out from the rest. We guarantee every door meets strict guidelines to ensure you and your families security.

Door Section Hardware	Torsion Springs	Track
Weather Protection	Premium Rollers & Hinges
High Wind Areas	Environment Friendly

Door Section Hardware
	*Exclusive, reversible, heavy 13 ga Top Roller Bracket. "L" brace if over 8' (2440)
		high.
	*Heavy duty, 12 ga, Lock-on Bottom Roller Bracket.
	*Patented 1.5" (38) inside flange with rolled edge for unsurpassed strength and
		longevity.
	*Reinforcing strut with rolled edge. Optional under 12' 3" (3730) wide.
	*Multi Contact, 17 ga structural support stiles with rolled edge.
	*Full length, 15 ga, Bottom Reinforcing Angle. 14 ga over 16' 2" (4930) wide. With
		the weather seal, door height is increased by about 5/8" (16) for better seal at
		the header.
	*Durable, double soft Bottom Weather seal. Cushions door when closing.
	*Martin Doors are made 2" wider than standard even foot increments.
		~Gives you a wider opening to drive through.
		~Provides a 1" overlap on each side for a better seal.

Long Life Torsion Springs and Hardware
	*Exclusive, high quality galvanized torsion spring(s).
	*Springs built to 30,000 cycle minimum life (Wood Line, Ranch and Hi-Tensil).
	*30 year Limited Warranty (Wood Line, Ranch and Hi-Tensil).
	*Lock-on Side Bearing Bracket and Anchor Bracket.
	*Spring winding cones with safety caps.
	*Center Bearing Bracket and Coupler.
	*Zinc plated torsion tube. 15 ga 11 ga or solid shaft.
	*Aluminum cast cable drum.
	*1/8" (3) minimum diameter Lift Cables.

Track

Heavy, Rolled edge Vertical Track.

17 ga = to 8' (2440)
15 ga = to 12' (3660)
14 ga = over 12' (3660) high

Heavy Horizontal Track

16 ga = 7' (2130) high
15 ga = to 12' (3660) high
14 ga = over 12' (3660) high

Heavy duty, 12 ga, Track Brackets combine with full length Reverse Angle Shields (Patent Pending). Reverse Bracket Shields on Montana.
Fastens solid to brick, block, concrete, stone, wood, sheet rock, etc. finished right to the edge.
Punched Angle track hangers (Optional).
Heavy duty, 12 ga Flag.

Unbeatable Weather Protection

*Heavy 24 ga Steel (Montana panels are 26 ga)

*2" (51mm) Thick Integral Design.

*Both sides of every Martin Door(except Montana)

*have 3 coats of unbeatable weather protection:.

	1st coat - Hot dipped G60 galvanizing to help prevent rust
	2nd coat - Thick coat of baked on enamel paint
	3rd coat - Thick coat of baked on enamel paint


Premium Rollers and Hinges
14 ga, Low profile hinges are heavy duty. 12 ga Roller Brackets. Amazingly quiet, 11 bearing steel rollers with special formula nylon tire and Roller Shield™(Hardened inner & outer racepacked in high/low temperature grease.)

	High Wind Areas			Environment Friendly
	Martin Series II Doors are built to wind load standards set by DASMA pub. #102-1976 and ANSI Bulletin A216.1 1977.			Insulation is not bonded to door sections allowing for section repair/recycling
				Insulation is removable, reusable and recyclable
	Note: For Extreme High Wind areas, Martin Doors* can be upgraded to specific wind loads.*			Martin Doors are friendlier to our trees